When you have bought a saw the natural desire of each customer - to test the tool. This seemingly simple process, there are "pitfalls". The thing structural features of chain saws.
NB: You can not run any chainsaw without pre-installed and adjusted the saw sets (tires, sprockets and chain). Otherwise, when you run this once "takes off" clutch. So do not pull the wire - read the instructions carefully. (Incidentally, if the import Saw came to our market through official channels, the statement must necessarily be in Russian.)After buying a chainsaw, be sure to "run" it 40-50 minutes at low speed (this is roughly equivalent to the development of the fuel tank), and then killed the engine and double-check the chain tension. Next you need to make some cuts, putting a weak effort, and only then go to work "in full."
Each new run-chain (or bus) to take a few minutes. It is done all to "star", the tire and the chain is well warmed up, and oil fell on all lubricated parts saw headset.
About 90 per cent of cases the cause of the release blade system is the neglect of the saw headset, and in particular, - inadequate care chain. In other words, when the chain is sharpened, it does work when blunt - you have to work, plus the additional increased load on the engine. Besides the obvious inconvenience this increase in load results in a significant reduction in service life of the tool
